User's Manual

RATTLER LRF USER MANUAL 19
3. Press the wheel to switch the PIP type. Up-Left, Center, Up-Right, and
Close are selectable.
4. Hold
button to exit.
If digital zoom is enabled, the PIP view also zooms. If the digital zoom ratio
exceeds 4, the PIP does not zoom.
2.2.9 DEFECTIVE PIXELS CORRECTION
Defective Pixels Correction (DPC) function can correct the defective pixels on
the screen which are not performed as expected.
Before you start switch the palettes mode to White Hot mode.
1. Hold
button to show the menu.
2. Rotate the wheel to select
DPC menu item, and press to enter the DPC
setting interface.
3. Press
button to switch the moving direction of the cursor. Rotate the
wheel to move the cursor until it reaches the defective pixel.
4. Press
to correct the defective pixel.
NOTE:
The selected defective pixel can be magnified and displayed at the bottom
right of the interface.
2.2.10 BURNING PREVENTION
This function can prevent damage to the thermal sensor from the sun or other
high temperature bright light source. When enabling this function, the shield
will close until the environment turns to normal.
1. Hold
button to go to the menu.
2. Rotate the wheel to select
menu item and press button to enable or
disable the Burn Prevention function.
NOTE:
When the burn-prevention function is disabled, the shield won’t be forced to
close in such conditions.
2.2.11 RETICLE AND BORESIGHTING
Enable the reticle to aim at the target.
1. Hold
button to show the menu.
2. Select
Reticle menu item. A reticle shows in the center of the view.
FIGURE 2-8. RETICLE PATTERNS
RETICLE 1 RETICLE 2 RETICLE 3 RETICLE 4 RETICLE 5