User's Manual

AGM Global Vision12
2.1.5 POWER ON AND OFF
Power On
When the battery is enough, hold the POWER button
to power on the device.
Refer to the figure below for the main view of the display.
Power Off
When the device is turned on, hold the POWER BUTTON
to power off the
device.
NOTE
See the battery icon on the device display for the electricity quantity. Icon
means the battery is fully charged, and icon means that the battery is low.
When the low power note shows, charge the battery.
In the “Auto Power Off” menu you can set the time for the automatic shutdown
of the device as required (OFF / 30 min. / 45 min.).
2.1.6 STANDBY MODE
Standby mode is used to save battery power. In the view mode, press the
button. After a few seconds, the display will turn off. Press the button again
to exit the Standby mode.
2.1.7 THERMAL VIEW OBSERVATION
1. Power on the device.
2. Hold the device and make sure the eyepiece covers your eye.
3. Adjust the diopter adjustment ring until the OSD text or image is clear.
4. Point the device towards the target of the view. Bring the object into focus by
rotate the objective focus ring.
NOTE:
You must perform the focus adjustment before any further use of the
riflescope.
5. Set palette, brightness, contrast, scene mode and FFC (Flat Field Correction),
to display the best image effect.
HOT SPOT
TIME AND DATE
BATTERY
DISTANCE
MEASUREMENT
RESULT
DIGITAL ZOOM STORAGE
FIGURE 2-4. THE DISPLAY MAIN VIEW