User manual

AGM Spread Spectrum Radio Manual

Diagnostics and Trouble Shooting

Diagnostic / Configuration Jumper

The SSR contains a diagnostic mode which will allow you to enter the configuration settings

regardless of the current configuration. This mode is entered by putting a jumper between

pins 1 and 5 on the green connector and cycling the power.

When in this mode the SSR will continuously transmit to the RS232 or RS485 connection a

count with each number followed by carriage return / line feed. The count will be transmitted

at the current baud rate and data format. You may use this count to determine the baud rate

of the SSR then match it with your terminal emulator program.

Entering “+++” will enter the configuration mode. You are in configuration mode when the

count stops and “OK” is returned. Configure the SSR as you would normally.

For normal operation you must remove the jumper. The jumper is for diagnostics only.