Product Manual

MENU OPTIONS
The user and service personnel can access information through the Set Up Mode. These are
the menu selections shown in Step 3 in the next section:
INFO Shows serial number, software version, number of working hours, and
service information. There are no values that can be changed.
SETTINGS Three settings can be changed; see instructions later in this section:
  • Theserviceintervalreminder(CHECKCAL)canbechangedfromthe 
default of 2000 hrs. to 500 or 1000 hrs.
  • Whenthereminderappearsonthescreen,itcanbeturnedoff
(and the counter reset to 0 hours).
  • Thestart-upscreencanbechangedfrom“AGL”toyour
company information.
CALIBRATION See instructions for “Adjusting Level Accuracy” later in the manual.
SERVICE A password is needed by service personnel to access this area.
Entering the Set Up Menu
1. Turn the laser off, and then turn the laser on
again.
2. When the AGL start-up screen is displayed,
press the + and ENT buttons simultaneously. Hold
until the Set Up screen appears (after the Battery
Check).
3. The cursor and highlighted text indicate the
active menu step.
Use the + or – buttons to move up or down the
menu. When you reach the desired step, such as
CALIBRATION, press ENT.
When you want to leave a menu section, move the
cursor to EXIT and press ENT.
17
Move DOWN the MenuMove UP the Menu
&