Instructions / Assembly

6
INSTALLATION
1. Identify parts packed in carton against the parts list. Remove all protective
materials and set parts on a flat, non-abrasive surface.
2. With the help of another person, carefully place the table top onto the table
base. After making any necessary adjustments to the alignment of the table
top and the assembled base, use four bolts and washers as shown in Figure 3.
Guide the bolts through the holes in the base brackets, into the pre-drilled
holes in the table top. Do not tighten completely.
Figure 3
3. Open the tank door, place the tank in the holder and connect the regulator
as shown in Figure 4. Turn the handle clock-wise to tighten. Turn the handle
counter clock-wise to remove. The hose must point down. Open the control
door and check that the valve is turned all the way clockwise to the “OFF”
position. Open the tank valve. Apply a solution of soapy water to the
tank-regulator connection and to the valve-hose connection to check for leaks.
If soap bubbles continue to form, the connection has a leak. If a leak is found,
close the tank valve and tighten all connections. NEVER USE A FLAME TO
CHECK FOR LEAKS.
Figure 4