Instructions / Assembly

7
4. Tighten the threaded knobs found on the tank tray (Figure. 5) so that the LP
tank cannot move from side to side. Do not remove plastic cap from end of
threaded section.
Figure 5
5. After making any necessary adjustments to the parts, use the hex bolt driver
to tighten all bolts. Note: each bolt must be tightened a few revolutions at a
time. Repeat until all bolts are tight. Do not over tighten. Over tightening may
strip bolts. Cover all bolts with covers.
6. Pour the fire ice into the burner completely covering the burner. See
Figure6.
Figure 6
Ignition Well
7. Remove the cardboard cover from the ignition well as shown in Figure 7.
Remove any fire ice on top of the ignition well.
Figure 7
Cardboard Cover
8. Open the tank valve. Apply a solution of soapy water to the tank-regulator
connection and to the valve-hose connection to check for leaks as shown in
Figure 8 If soap bubbles continue to form, the connection has a leak. If a leak
is found, close the tank valve and tighten all connections.
NOTE: NEVER USE A FLAME TO CHECK FOR LEAKS.
Checking the tank-regulator for leaks
Figure 8