Use and Care Manual

10
BATTERIES
Make sure the control knob is in the "OFF" position. Unscrew the
push button cap on the ignition module located on the control
panel to access the battery compartment. The ignition module
requires one Alkaline AA size battery (1.5V). The negative (-) end
goes in first. See Figure 10. Dispose of the battery safely as it may
explode or leak if charged or disposed of in a fire. Make sure of the
polarity. Mercury and cadmium free.
Figure 10
CAUTIONS: BATTERY INSTRUCTIONS
●Always purchase the correct size and grade of battery most suitable for the intended use.
●Always replace the whole set of batteries at one time, taking care not to mix old and new ones, or batteries of different types.
●Clean the battery contacts and also those of the device prior to battery installation.
●Ensure the batteries are installed correctly with regard to polarity (+ and -).
●Remove batteries from equipment which is not to be used for an extended period of time.
●Remove used batteries promptly.
For recycling and disposal of batteries to protect the environment, please check the internet or your local phone directory for
local recycling centers and / or follow local government regulations.
LIGHTING INSTRUCTIONS
Warning: If these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
1. Read instructions before lighting.
2. Push the control knob in and turn the knob to ON.
3. Hold the ignitor to light the burner, release the control knob after 15 seconds. If the burner
does not light, wait 5 minutes, repeat.
4. Adjust the flame to desired amount by using the control knob. See Figure 11.
IGNITER BUTTON CONTROL KNOB
Figure 11