Service manual

2 X/P/K281C Operating and Service Manual
General Information
Option 012 Option 012 for the X281C offers a Type-N (m) connector to replace the
standard 7-mm connector.
Option 013 Option 013 for the X281C offers a Type-N (f) connector to replace the
standard 7-mm connector. Option 013 is not offered for the K281C and the
P281C.
Instruments Covered by Manual
The adapters covered by this manual have a two part serial number. The first
four digits and letter constitute the serial number prefix. The last five digits
form the sequential suffix that is unique to each adapter. The contents of this
manual apply to adapters prefixed at 3032A and above.
Incoming Inspection
Inspect the shipping container for damage. Inspect the adapter for any
mechanical damage incurred in transit. If the shipping container or
cushioning material is damaged, it should be kept until the contents of the
shipment have been checked for completeness, and the adapter has been
checked mechanically and electrically.
Returning for Service
If you need to return the adapters for service, complete one of the blue repair
tags located at the end of this manual and attach it to the device. If no repair
tag is available, attach a tag indicating the type of service required, your
return address, model number, and serial number of the adapter to be
repaired.
Repackaging the adapter requires original shipping containers and materials
or their equivalents. Agilent can provide packaging materials identical to the
original materials. To contact the Agilent Technologies nearest you, refer to
“Service and Support” on page iv.
Storage and Shipment Environment
Store the adapter in a clean, dry environment. The following environmental
limitations apply to both storage and shipment.
Temperature
− 55 to 75 °C
Humidity < 95% relative at + 40
°C
Altitude < 15,000 meters (50,000 feet)