Service manual

X/P/K281C Operating and Service Manual 7
Replaceable Parts
Replaceable Parts
Replaceable parts for P281C adapter are shown below. Refer to Table 4,
Table 5, and Table 6 for identification of parts and corresponding part
numbers for all models. For ordering information, contact the nearest
Agilent office listed in “Service and Support” on page iv.
Figure 3 Replaceable Parts
NOTE Table 1 on page 1 gives dimensional tolerances for Option 006 that can be
expected to yield satisfactory results. It may be necessary to try various
combinations of spacers and shims to obtain proper dimensions. The use of
at least one shim is recommended because of electro-chemical differences
between the connector body and the adapter body. Refer to the appropriate
table of replaceable parts for the thickness of shims and spacers.
CAUTION Take care to avoid damaging parts. Burring, scratching, denting or
deforming parts may impair operating characteristics.