user manual

Performing Tests

Overview

Chapter 4

O:\Manuals\E6385A_Amps\Book\perftst.fm

Running Tests

NOTE Before starting to run operational tests, make certain that you have set PARAMETER

32. ZZZZ Test Demo Mode [0=normal 1=demo] to 0.

You are now ready to select and run tests. On the Test Selections Menu screen, scroll to

the test that you wish to run, and press the knob to select it. The test will run. You may

then select another test and run it in the same manner. You may repeat this operation as

many times as is necessary.

After successfully running the tests, it is recommended that you save all of the

configuration information as a procedure file on an SRAM card for later retrieval (see

“Saving/Deleting a Procedure” on page 109). This eliminates the requirement for

re-entering the information if you run a different program, change parameters when

testing another Base Station, or install new operating system firmware in the Test Set.

For More Information

For more details on the tests in this chapter:

• “Parameters” on page 118

• “Specifications (Pass/Fail Limits)” on page 124

If there were problems or error messages were displayed when running a test:

See Chapter 6, “Troubleshooting,” on page 129.