user manual

Quick Start Guide 2-15
ESG Family Signal Generators Exploring the User Interface
Rear Panel
26. BER DATA IN Use this connector to input the data streams for the bit-error-rate
measurements. This female BNC connector is present only on
instruments with Option UN7.
27. BER CLK IN Use this connector to input the clock signal for the bit-error-rate
measurements. This female BNC connector is present only on
instruments with Option UN7.
28. BER GATE IN Use this connector to input the clock gate signal for the
bit-error-rate measurements. The connector can be enabled or
disabled by a softkey or an GPIB command. This female BNC
connector is present only on instruments with Option UN7.
29. 321.4 MHz IN Use this connector to input a downconverted 321.4 MHz GSMsignal
for base transceiver station (BTS) loopback measurements. This
female SMB connector is present only on instruments with
Option 300.
qsg.book Page 15 Friday, September 22, 2000 3:13 PM