User`s guide

Using Operator Interfaces Chapter 11
VEE User’s Guide 431
21 Open the warning UserFunction Properties box, select
ShowPanelonExecute, set the ShowPopupPanelTitle to
False (since the title serves no purpose to the operator).
22 Go to Main and click Device ⇒ Call, open its object menu,
click Select Function, then select warning. Move the Call
object to the top center of the screen. Iconize the Main
window.
23 By default, VEE displays both the alarm and the warning
panels in the center of the screen, so the alarm will blink
on top of the check box that will stop the alarm. Since
both of these screen positions are not locked, you can
reposition them on the screen by clicking and dragging
the pop- up panels to new locations. However, with the
alarm panel blinking this is somewhat difficult. Instead,
click and drag the edge of the panel. If needed, stop the
program using the stop button on the tool bar. Run the
program.
When you have the two panels positioned as shown in
Figure 244, you can stop the program by clicking the box
next to the Turn off alarm? prompt.