User`s guide

Test Sequencing Chapter 10

VEE User’s Guide 379

Make sure the transaction is highlighted, place the cursor on

the transaction bar, press Ctrl-K to cut the test, then press

Ctrl-Y three times to paste the test back into the Sequencer.

(You could also cut and paste using the object menus.)

The default test names will be test1x2, test1x1, and test1.

Open the three Sequence Transaction dialog boxes and

change these names to test1, test2, and test3 for clarity.

1 Select Data ⇒ Continuous ⇒ Real64 Slider and place it to the

left of the Sequencer. Change the name to the prompt Select

Num:, size the object to be smaller, and connect it to the

Sequencer input terminal.

You can size an object as you place it by clicking and dragging

the object corners using the left mouse button.

2 Select an AlphaNumeric display, place it below the

Sequencer, enlarge it to be wider, and connect it to the Log

output terminal on the Sequencer.

3 Save the program again as seqdat1. Select a number on

the Real64 Slider object and run seqdat1. It should look

Figure 209.