Technical data

40 U4154A Logic Analyzer Service Guide
3 Testing U4154A Performance
Test the U4154A Module
The following sections explain how to test the maximum
state data rate.
1 Record the U4154A logic analyzer’s model and serial
number in the Performance Test Record (see page 62).
Record your work order number (if applicable) and
today’s date.
2 Record the test equipment information in the “Test
Equipment Used” section of the Performance Test Record.
3 Turn on the AXIe chassis.
a Plug in the power cord to the power connector on the
rear panel of the AXIe chassis.
b Press the ON/Standby button on the front panel of the
chassis to power on the chassis.
While the logic analyzer is booting, observe for the
following:
• Ensure all of the installed memory is recognized.
• Any error messages.
• Interrupt of the boot process with or without error
message.
4 During initialization, check for any failures.
If an error or an interrupt occurs, refer to the
troubleshooting section.
NOTE
Before testing the performance of the module, warm-up the logic analyzer
and the test equipment for 30 minutes.