Technical data

12 U4154A Logic Analyzer Service Guide
1 General Information
Accessories
One or more of the following accessories, sold separately, are
required to set up and operate the U4154A logic analyzer
module for testing and servicing it.
Probing Accessories
For information about probing accessories for logic analyzers
with 90- pin pod connectors, see the Probing Solutions for
Logic Analyzers Catalog, literature part number 5968- 4632E,
available on Agilent’s web site (www.agilent.com).
U4201A Pod Connector Cables
The Agilent U4201A 90- pin pod connector cable is used to
connect the U4154A module with the probes which then
connect to the DUT/SUT. You need four U4201A pod cables
for a U4154A module. Refer to the U4154A Logic Analyzer
Installation Guide to learn more about these cables.
Chassis and software
The U4154A logic analyzer requires:
• M9502A or M9505A Agilent AXIe chassis that provides
slots for installing the U4154A module.
• A host PC which is a laptop or a desktop PC with a PCIe
interface. The host PC connects to the Agilent AXIe
chassis via PCIe interface and is used to host all the
required software components of the U4154A module for
configuring, controlling, and using this module.
• Agilent Logic Analyzer software version 05.00 or higher to
configure, control, and use the U4154A module.
Refer to the U4154A Logic Analyzer Installation Guide to
learn more about AXIe chassis, host PC, and the Logic
Analyzer software installation.