User`s guide

Operation and Features 2
Math Operations
U3606B User’s Guide 69
MinMax
The MinMax operation stores the minimum and maximum
values, the average, and the number of readings during a
series of measurements. From the front panel, you can view
the following statistical data for any set of readings: average
or mean (Avg), maximum (Max), minimum (Min), or present
reading (MaxMinAvg).
NOTE
• This math operation applies to all measurement functions except
continuity and diode test.
• The stored statistical data are cleared when statistics are enabled,
when the
CALculate:FUNCtion command is sent while the
CALCulate:STATe is ON, when the power is turned off, after a
Factory Reset (
*RST command), after an Instrument Preset
(
SYSTem:PRESet command), or after a measurement function
change.
• The average function can be restarted by pressing [MinMax] for more
than one second.
Enable the MinMax function
To disable the MinMax function
U3606-90054_UG_EN.book Page 69 Friday, July 11, 2014 5:12 PM