User`s guide

1 Introduction
The U3606B in Brief
22 U3606B User’s Guide
• Press [] to select a higher range and disable autoranging.
• Press [] to select a lower range and disable autoranging.
Press [Shift] > [Auto] to enable autoranging and disable manual ranging.
Press [Shift] > [4½ 5½] to toggle between 4½ digit and 5½ digit mode.
[3]
Press [Shift] > [Trig] to enable the single trigger operation.
Source operation
Press [Voltage] to select CV output. Use the arrow keys to select a suitable
voltage value.
Press [Current] to select CC output. Use the arrow keys to select a suitable
current value.
• Press [] to select the square-wave output. Use the arrow keys to set
the voltage amplitude.
• Press [] again to cycle through the duty cycle, pulse width, and voltage
amplitude settings.
When the annunciator is flashing, press [] or [] to step through the
available frequencies.
While the annunciator is flashing, press [] or [] to set the voltage
amplitude, or to step through the available duty cycle values or pulse width
values.
Press [Sweep] to cycle through the ramp and scan sweep functions, or to
disable the sweep operation for the selected output (CV or CC).
[4]
Table 1 - 4 Keypad descriptions (continued)
Legend Description
U3606-90054_UG_EN.book Page 22 Friday, July 11, 2014 5:12 PM