User`s guide

List of Error Messages 6
Error Messages
U3606B User’s Guide 187
Calibration errors
The following errors indicate failures that may occur during
a calibration.
643 Frequency measurement path failed
644 Constant Current 0.2V/1kohm error
645 Constant Current 0.2V/10kohm or amplified 11 error
646 Constant Current 0.8V/100kohm or amplified 11 error
647 Constant Current 0.8V/1.1Mohm or amplified 11 error
Table 6 - 6 List of self-test errors (continued)
Error code Error message
Table 6 - 7 List of calibration errors
Error code Error message
701 Cal security pads short
702 Cal secured
703 Invalid secure code
704 Secure code too long
705 Cal aborted
706 Cal value out of range
707 Cal signal measurement out of range
708 Cal signal frequency out of range
709 Cal source unfinished
710 EEPROM write failure
720 Cal DCV offset out of range
721 Cal DCI offset out of range
722 Cal RES offset out of range
U3606-90054_UG_EN.book Page 187 Friday, July 11, 2014 5:12 PM