User`s guide

4 System-Related Operation
Utility Menu Items
144 U3606B User’s Guide
Configuring the beeper
Normally, the U3606B beeps whenever certain conditions are
met (for example, the U3606B beeps when a stable reading
is captured in reading hold mode). The beep driving
frequency is set to “3840 Hz” by default, but may be disabled
through the front panel.
When the beep driving frequency is set to “2400 Hz” or
“3840 Hz”, a single beep occurs for the following cases
(turning the beeper “oFF” disables the beep for the following
cases):
• When a new minimum (Min) or maximum (Max) value is
stored.
• When a new stable reading is updated on display for hold
operation.
• When a measurement exceeds the high (HI) or low (LO)
limit value.
• When a forward- biased diode is measured in the diode
function.
• When a continuity measurement is less than or equal to
the continuity threshold.
• When a SYSTem:BEEPer command is sent from the
remote interface.
• When an error is generated.
Press [] or [] to change the beep driving frequency.
Select “oFF” to disable the beeper.
U3606-90054_UG_EN.book Page 144 Friday, July 11, 2014 5:12 PM