User`s guide

System-Related Operation 4
Utility Menu Items
U3606B User’s Guide 139
Press [] or [] to change the ramp signal amplitude end
position.
Press [] or [] until the cursor is position on the ramp
signal number of steps. Press [] or [] to change the
number of steps for the ramp signal to increment from zero
to the amplitude end position.
CV/CC ramp signal parameters Ramp signal range
Amplitude end position
(NN.NNN V or N.NNNN A)
Number of
steps (NNNNN)
NOTE
• The increment of each step in the ramp signal will be the amplitude end
position divided by the number of steps. For example, a 15 V amplitude
end position divided by 100 steps gives an increment of 0.15 V per step.
• The ramp dwelling time selected will be fastest of the instrument
output capability. (Typically ~100 ms per step.)
U3606-90054_UG_EN.book Page 139 Friday, July 11, 2014 5:12 PM