User`s guide

System-Related Operation 4
Utility Menu Items
U3606B User’s Guide 137
Press [] or [] to change the scan signal amplitude end
position.
Press [] or [] until the cursor is position on the scan
signal number of steps. Press [] or [] to change the
number of steps for the scan signal to increment from zero
to the amplitude end position.
Press [] or [] until the cursor is position on the scan
signal dwelling time. Press [] or [] to change the scan
signal dwelling time.
CV/CC scan signal parameters Scan signal range
Amplitude end position
(NN.NNN V or N.NNNN A)
Number of
steps (NNN)
Scan dwelling
time (NN s)
NOTE
• The increment of each step in the scan signal will be the amplitude end
position divided by the number of steps. For example, a 15 V amplitude
end position divided by 100 steps gives an increment of 0.15 V per step.
• The scan signal will “dwell” in the present step for the length of time
stated in the scan dwelling time before incrementing to the next step.
U3606-90054_UG_EN.book Page 137 Friday, July 11, 2014 5:12 PM