User`s guide

4 System-Related Operation
Utility Menu Summary
128 U3606B User’s Guide
db.rEF NNNN Ω
Set dB reference impedance value from 1 Ω to
9999 Ω.
page 142
SELF.t no YES
• If “YES” is selected, the instrument exits the
Utility menu and immediately executes the
self-test.
• After the self-test completes, the instrument
returns to normal operation.
page 142
iob
GPib U-CdC U-tMC
• Select “GPib”, “U-tMC”, or “U-CdC” as the
desired remote interface connection.
• “USB-tMC” simulates the USB interface
according to USB-TMC standard.
• “USB-CdC” is used to simulate the
communication port.
page 143
NN Set the GPIB address from 1 to 30.
bEEP 2400 Hz 3840 Hz oFF
• Set the beep driving frequency to “2400 Hz”
or “3840 Hz”.
• Set “oFF” to disable the beep tone.
page 144
P-on rESEt LASt
• Set “LASt” to recall the last known power-off
state when power is turned on.
• Set “rESEt” to recall the default factory
power-on state when power is turned on.
page 145
diSP L-03 L-02 L-01 Cycle through the VFD display brightness levels. page 146
P.CodE NN.NN iob NN.NN Sb NN.NN Mb
• Select “iob” to view interface board program
code revision.
• Select “Sb” to view source board program
code revision.
• Select “Mb” to view measurement board
program code revision.
page 146
Table 4 - 1 Utility menu summary (continued)
Item Available settings Description Link
U3606-90054_UG_EN.book Page 128 Friday, July 11, 2014 5:12 PM