User`s guide

System-Related Operation 4
Utility Menu Summary
U3606B User’s Guide 127
SMoth
oF on
Select “oF” to disable the smooth function, or
“on” to enable the smooth function.
page 133
FC-N.N %
• Set the fluctuation count from 0.0 % to 9.9 %.
• Set the count to 0.0 % to disable the
fluctuation function.
NNNN Set the number of points from 2 to 1999.
SCAn
CV CC
• Press [Voltage] to select scan setup for CV.
• Press [Current] to select scan setup for CC.
page 136
S1/S2/S2m S1/S1m/S2
Press [Shift] > [Range] to toggle between range
S1 (30 V/1 A), S1m (30 V/100 mA), S2 (8 V/3 A),
or S2m (1000 mV/3 A)
NN.NNN V N.NNNN A NNN-NN s
• The increment of each step will be the
amplitude end position (NNNN.N mV/
NNN.NN mA) divided by the number of steps
(NNN).
• Set the scan dwelling time (NN s) from 1 s to
99 s.
rAMP
CV CC
• Press [Voltage] to select ramp setup for CV.
• Press [Current] to select ramp setup for CC.
page 138
S1/S2/S2m S1/S1m/S2
Press [Shift] > [Range] to toggle between range
S1 (30 V/1 A), S1m (30 V/100 mA), S2 (8 V/3 A),
or S2m (1000 mV/3 A)
NN.NNN V N.NNNN A NNNNN
• The increment of each step will be the
amplitude end position (NNNN.N mV/
NNN.NN mA) divided by the number of steps
(NNNNN).
• The ramp dwelling time will be fastest of
output capability (typically ~100 ms per step).
triP YES no
• Select “YES” to enable the output protection
or “no” to disable the output protection.
• The factory default for the output protection
state is “YES”.
page 140
SoFt.S
StEP
NNNNN Set the soft start rising step from 1 to 10000. page 141
Table 4 - 1 Utility menu summary (continued)
Item Available settings Description Link
U3606-90054_UG_EN.book Page 127 Friday, July 11, 2014 5:12 PM