User`s guide

4 System-Related Operation
Utility Menu Summary
126 U3606B User’s Guide
Utility Menu Summary
The Utility menu items are summarized in the table below.
For further explanations on the various items in the Utility
menu, see the respective menu item headings.
Table 4 - 1 Utility menu summary
Item Available settings Description Link
Error nonE (–)Er.NNN
• Review the last recorded error message (up to
20 error messages).
• Review all the recorded error messages to
clear the Error annunciator.
page 129
dAtA NNNNN NNNNN s
• Set the data logging loop number (NNNNN)
from 1 to 29000.
• Set the data logging interval time (NNNNN s)
from 1 s to 99999 s.
page 130
LoG
FiLE
StoP Cont StArt
• Select “StArt” to start the data logging
operation (this operation overwrites any
previously logged data).
• Select “StoP” to stop the data logging
operation.
• Select “Cont” to resume a data logging
operation from where it was last stopped.
page 131
rHoLd t - NNN % nH - N.N %
• Set the refresh hold variation (t - NNN %) in
percentage. When the variation of the
measuring value exceeds the preset setting,
the refresh hold will be ready to trigger.
• Set variation to “oFF” to enable data hold
mode.
• Set the refresh hold threshold (nH - N.N %) in
percentage for voltage, current, and
capacitance measurements. The reading
value will not be updated when the reading
falls below the threshold value.
page 132
U3606-90054_UG_EN.book Page 126 Friday, July 11, 2014 5:12 PM