User`s guide

3 DC Power Supply Operation
Remote Sensing
116 U3606B User’s Guide
Remote sensing connections
Remote sensing requires connecting the load leads from the
rear output terminals to the load as shown below. Observe
the polarity when connecting the sensing leads to the load.
Figure 3-1 Remote sensing connections
Figure 3-2 Local sensing connections
NOTE
The metal shorting bars should be removed from the rear output and sense
terminals for remote sensing connections. For local voltage sensing
connections, the sense leads must be connected to the output terminals.
+S + + – – –S
LOAD
Rear output terminals
Shielded two-wire cable
+S + + – – –S
LOAD
Rear output terminals
Short bar
Short bar
U3606-90054_UG_EN.book Page 116 Friday, July 11, 2014 5:12 PM