User`s guide

3 DC Power Supply Operation
Square-Wave Operation
104 U3606B User’s Guide
Adjust the frequency, duty cycle, or pulse width values and save the changes
Use the arrow keys to change the value.
• Press [] or [] to step through the available frequencies.
• Press [] or [] to step through the available duty cycle (or pulse width) values.
Note: To adjust the frequency value, the duty cycle or pulse width values must be
shown on the display.
4
To exit the edit mode
5
NOTE
• Pressing [] again will save the changes, and display the next
square-wave parameter. (While still in the edit mode.)
• While adjusting the amplitude, duty cycle, and pulse width values you
can also press [Shift] > [Exit] to exit the edit mode.
• The square-wave amplitude is limited by the range selected. Press
[Shift] > [Range] to select an appropriate range. You can only select a
range when the output is disabled (the SBY annunciator is illuminated).
• Changing the square-wave frequency value will affect the square-wave
duty cycle and pulse width values as they are inter-related.
U3606-90054_UG_EN.book Page 104 Friday, July 11, 2014 5:12 PM