Technical data

U3606A Quick Start Guide 19
Editing the scan signal properties:
1 To edit the properties of the scan signal, you will need to access the
utility menu. Press Shift > Utility to access the utility menu.
2 Press or to step through the menu items until “SCAn” is shown
on upper secondary display.
3 Use the directional keys to edit the signal properties.
4 After configuring the scan signal parameters, press Shift > Save to save,
and Shift > Exit to exit the utility menu.
See Chapter 4, “System Related Operation” in the U3606A User’s and
Service Guide for more information on changing the ramp and scan signal
properties.
Amplitude end position
(NN.NNN V or N.NNNN A)
Number of
steps (NNN S)
Scan dwelling
time (NN s)
CV/CC scan signal parameters Scan signal range
NOTE
The ramp and scan signal amplitude end positions are limited by the range
(S1 or S2) and output type (CV or CC) selected.