Technical data

18 U3606A Quick Start Guide
Using sweep functions
The U3606A comes equipped with ramp and scan capability.
• When the ramp function is enabled, the Ramp annunciator will
illuminate.
• When the scan function is enabled, the Scan annunciator will
illuminate.
Editing the ramp signal properties:
1 To edit the properties of the ramp signal, you will need to access the
utility menu. Press Shift > Utility to access the utility menu.
2 Press or to step through the menu items until “rAMP” is shown
on upper secondary display.
3 Use the directional keys to edit the signal properties.
4 After configuring the ramp signal parameters, press Shift > Save to save,
and Shift > Exit to exit the utility menu.
Key Description
Press Sweep to cycle through the ramp and scan sweep functions, or to
disable the sweep mode for the selected output (CV or CC).
[1]
[1] The sweep functions can only be accessed when the U3606A is in constant voltage or constant
current mode. You cannot access the sweep functions while the U3606A is in square-wave output
mode.
Amplitude end position
(NN.NNN V or N.NNNN A)
Number of steps
(NNNNN S)
CV/CC ramp signal parameters
Ramp signal range