Technical data

IEEE-488.2 Common Commands 6
U2751A Programmer’s Reference Guide 31
*ESE/*ESE?
Syntax
*ESE <enable_value>
This command enables the bits in the enable register for the Standard
Event register group. The selected bits are then reported to bit 5 of the
Status Byte register.
*ESE?
This will query the Standard Event enable register group.
Parameter
NOTE
For more information on the system registers, refer to Chapter 2, “SCPI Status
Registers” on page 9.
Item Type Range of values Default value
<enable_value> NR1 A decimal value that corresponds to the
binary-weighted sum of the bits in the register.
Refer to the table below.
This is a required
parameter.