Installation guide

8
How Does It Work? (continued)
N9340A Handheld Spectrum
Analyzer
• Turns the handheld spectrum analyzer
into power meter. Displays power
measurement with its user interface
(UI), which integrates the display of
power measurements.
Keystrokes surrounded by [ ] represent
front-panel hardkeys of the instruments,
while keystrokes surrounded by { }
represent softkeys.
Instructions
1. Power up the N9340A. Connect the U2000 Series USB power sensor to the USB port
of the N9340A (see Figure 13).
2. Press [Mode], use [↑] or [↓] key to select the {Power Meter} then press [ENTER]
(see Figure 14).
Power Meter Menu
• Zeroing: Access to zeroing and calibration menu
• Meas Disp: Access to measurement display menu and confi gure the displayed
measurement resolution and format
• Meas Setup: Set up the relative measurement or set display offsets.
• Preset: Preset the USB power sensor
Figure 13 HHSA connect with USB power sensor.
Figure 14 N9340A HHSA turns into a power-meter measurement