Installation guide

Dual Power Meter Display

Function on MXG

The dual power meter display function can

be used to display the current frequency

and average power of either one or two

power sensors. For each channel, you can

control the settings for On/Off, channel

frequency, channel offset, averaging and

measurement units, and the dual power

meter display feature. To use two U2000

series power sensors with the MXG, an

USB hub (with power supply) can be

connected to the MXG’s front panel USB

connector (see ﬁ gure 21). Figure 22 shows

the dual power meter display function on

MXG signal generator.

Figure 21 Connection diagram of two USB power sensors on MXG via external USB hub

Figure 22 Dual power meter display function on MXG signal generator

The U2000 Series USB power sensors are compact and portable, easy to use, and cost

effective for you as it provides the following beneﬁ ts:

• Compatibility with other Agilent instruments such as vector network analyzer,

spectrum analyzer, signal generator, cable and antenna tester, and FieldFox RF

analyzer.

• Portability for ﬁ eld application. The smaller size and light weight of the USB power

sensors allow you to carry it to the site for ﬁ eld applications.

• Simpliﬁ ed measurement setup with USB power, plug-and-play connectivity, and built-

in triggering circuit.

• Lower cost without compromising on performance or quality. Standalone USB power

sensors do not need a power meter to provide accurate power measurement via PC/

laptop or other Agilent instruments.

Conclusion

U2000 Series USB Power Sensor

N5183A MXG

USB Port