Technical data

Using the Agilent GUI Data Logger
8 Agilent GUI Data Logger Quick Start Guide
Automatic - Up to x count mode
The Automatic- Up to x count mode allows the data to be
transferred to the PC at a specific logging count and log
interval set by you.
Procedures:
1 In the Logging panel, select Automatic - Up to x count mode in
the Logging Mode drop down list.
2 Set the desired Logging Interval in seconds and Logging
Count by clicking on the up/down button or by keying in
the required value.
Figure 10 Logging panel with Automatic - Up to x count selected
3 Click Start to start the data logging. The logged data will
be displayed in the measurements table.
Figure 11 Logged data