Technical data

Using the Agilent GUI Data Logger
6 Agilent GUI Data Logger Quick Start Guide
Automatic - Continuous mode
The Automatic - Continuos mode allows the data to be
transferred to the PC automatically and continuously with a
specific log interval.
Procedures:
1 In the Logging panel, select Automatic - Continuous in the
Logging Mode drop down list.
2 Set the desired Logging Interval in seconds by clicking on
the up/down button or by keying in the required value.
Figure 7 Logging panel with Automatic - Continuous selected
3 Click Start to start the data logging. The logged data will
be displayed in the measurements table.
NOTE
• The Logging Interval is defined as the delay within the PC when it is
sending a command to fetch the latest reading.
• The Logging Interval’s best effort for communication between the PC
and the LCR meter is subjected to the following conditions:
• It is dependant on PC activity for USB communications.
• It is not a true realtime-stamp.
• It is subjected to software delays when sending commands to obtain
readings.
• In this mode, the Logging Count option is disabled.