Technical data

Calibrator Output Operations 2

U1401A User’s and Service Guide 39

used to indicate the start or end position. The last three

digits of the primary display are used to indicate the

number of steps (the number of steps from start to end).

1 Press MODE to cycle through position (start or end),

number of steps, and amplitude adjustment. The digit to

be adjusted will flash on the display.

• For adjusting the amplitude, press and to select

the digit to be adjusted, then press and to

adjust the value of the selected digit. The amplitude

can be set to any value within the selected output

range (±1.5 V or ±15 V for constant voltage output, ±25

mA for constant current output).

• For adjusting the number of steps, press and to

select the digit to be adjusted, then press and

to adjust the value of the selected digit. The number of

steps can be set within the range of 0 to 999 steps.

• Press for more than one second to directly reset

the time interval and amplitude of the present step to

zero.

2 Press OUTPUT to save the settings.