Technical data

36 U1401A User’s and Service Guide
2 Calibrator Output Operations
2 Press OUTPUT to save the settings.
Autoramp output
To set the autoramp output:
1 Turn the rotary switch to any one of the or
positions.
2 Press SHIFT to access the shifted operations of the keypad.
The annunciator will appear on the display.
3 Follow one of the instructions below:
• For voltage output, press MODE to cycle through ±1.5 V,
±15 V, ±1.5 V, ±15 V, ±1.5 V, and
±15 V output modes. Select either of the two
(autoramp) output modes, depending on the
voltage range you require.
• For current output, press MODE to cycle through
±25 mA, ±25 mA, and ±25 mA output
modes. Select the output mode.
Figure 2-3 Defining the autoscan output
16 memory
locations
0 to 99 sec
time
interval
Output amplitude