User`s guide

Getting Started 2
Agilent 34980A Mainframe User’s Guide 29
Wiring and Installing a Terminal Block
If you are planning to use an optional terminal block with your plug- in
modules, follow the next two procedures to connect your external wiring
and install a terminal block.
Wiring a Terminal Block
1 To remove the terminal block cover, insert a screwdriver through the
hole in the cover as shown. Gently push the tab in the direction of the
arrow.
2 While pushing the tab (Step 1), lift the clear plastic cover from the
edge near the D- sub connectors. Slide the cover from under the tab
holders and remove the cover.
WARNING
Before you begin this task, make sure you have disconnected power
from all external field wiring you will be connecting to the terminal
block.
NOTE
For plug-in module pinout diagrams and additional information, refer to
the User's Guide(s) shipped with the module(s).