User`s guide

28 Agilent 34980A Mainframe User’s Guide
2 Getting Started
2
Remove the two flathead screws from the support sleeve.
3 Fit the terminal block support sleeve against the module so the
openings on the sleeve line up with the connectors and the center
screw hole as shown.
4 Replace the panhead screw. Then replace and tighten the two flathead
screws to secure the sleeve to the module.
5 Install the module into a mainframe slot until it fully seats with the
backplane connector. Using a Pozidriv #1 screwdriver, tighten the two
screws to secure the module in the mainframe. Installation of the
support sleeve is now complete.