Network Card User Manual

15
MPEGscope Portable and Portable Lite
Step 2: Remove optional interface
Complete this step if your MPEGscope already has an optional interface installed
and you want to replace it with the SMPTE 310M interface.
1
Attach the antistatic wrist strap to your wrist and to the PC chassis as described in the
instructions on the envelope. Ensure that the copper foil end of this strap attaches to an
electrical ground.
IMPORTANT
:
2
If your MPEGscope has a Real-time Analyzer, disconnect
the ribbon cable connector from the Real-time Analyzer
card. The cable runs from the MPEGscope main card to
the Real-time Analyzer card.
4
Remove the faceplate screw from slot 2
with the screwdriver provided, then
remove the optional line interface.
3
If your optional line interface is connected to the
MPEGscope main card with a cable, disconnect
the cable from the optional interface card.
5
If your optional line interface is
connected to the MPEGscope main
card with a cable, disconnect the other
end of the cable from the MPEGscope
main card and remove the cable.