User`s guide

1 Quick Reference
20 Series N6700 User’s Guide
SCPI Command Description
[SOURce:]LIST:TOUTput (continued)
:DWELl <NRf> {,<NRf>}, (@chanlist)
Sets the list of dwell times
:POINts? (@chanlist)
Returns the number of dwell list points
:STEP ONCE | AUTO, (@chanlist)
Specifies how the list responds to triggers
:TERMinate
:LAST <Bool>, (@chanlist)
Sets the list termination mode
:TOUTput
:BOSTep
[:DATA] <Bool> {,<Bool>}, (@chanlist)
Generate triggers at the Beginning Of Step
:POINts? (@chanlist)
Returns the number of beginning of step list points
:EOSTep
[:DATA] <Bool> {,<Bool>}, (@chanlist)
Generate triggers at the End Of Step
:POINts? (@chanlist)
Returns the number of end of step list points
:VOLTage
[:LEVel] <NRf> {,<NRf>}, (@chanlist)
Sets the voltage list
:POINts? (@chanlist)
Returns the number of voltage level points
POWer
:LIMit <NRf+>, (@chanlist)
Sets the power limit on output channels
RESistance
[:LEVel][:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the output resistance (only on N6781A)
:STATe <Bool>, (@chanlist)
Enables/disables output resistance programming (only N6781A)
STEP
:TOUTput <Bool>, (@chanlist)
Generate a trigger output on the voltage or current step transient
VOLTage
[:LEVel]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the output voltage
:TRIGgered [:AMPLitude] <NRf+>, (@chanlist)
Sets the triggered output voltage
:BWIDth LOW | HIGH1 | HIGH2 | HIGH3, (@chanlist)
Sets the voltage bandwidth (only on N678xA SMU)
:LIMit
[:POSitive]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the positive voltage limit (only on N678xA SMU)
:COUPle <Bool>, (@chanlist)
Sets the voltage limit tracking state (only on N6784A)
:NEGative
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the negative voltage limit (only on N6784A)
:MODE FIXed | STEP | LIST, (@chanlist)
Sets the voltage trigger mode
:PROTection
[:LEVel] <NRf+>, (@chanlist)
Sets the over-voltage protection level
:DELay[:TIME] <NRf+>, (@chanlist)
Sets the over-voltage protection delay (only on N6783A)
:REMote
[:POSitive][:LEVel] <NRf+>, (@chanlist)
Sets the positive remote OV protection level (only on N678xA SMU)
:NEGative[:LEVel] <NRf+>, (@chanlist)
Sets the negative remote OV protection level (only on N6784A)
:TRACking
(Tracking commands only on Option J01)
[:STATe] <Bool>, (@chanlist)
Enables/disables tracking OVP
:OFFSet <NRf+>, (@chanlist)
Sets the tracking OVP offset
:RANGe <NRf+>, (@chanlist)
Sets the output voltage range
:SLEW
[:IMMediate] <NRf+> | INFinity, (@chanlist)
Sets the output voltage slew rate
:MAXimum <Bool>, (@chanlist)
Enables/disables the maximum slew rate override