User`s guide

Quick Reference 1
Series N6700 User’s Guide 19
SCPI Command Description
SENSe (continued)
:SWEep
(Sweep commands only on N676xA, N678xA SMU and Option 054)
:OFFSet
:POINts <NRf+>, (@chanlist)
Defines the trigger offset in the measurement sweep
:POINts <NRf+>, (@chanlist)
Defines the number of data points in the measurement
:TINTerval <NRf+>, (@chanlist)
Sets the measurement sample interval
:RESolution RES20 | RES40, (@chanlist)
Sets the measurement resolution
:VOLTage
[:DC]:RANGe
[:UPPer] <NRf+>, (@chanlist)
Selects the voltage measurement range
:AUTO <Bool>, (@chanlist)
Enables/disables measurement autoranging (N6781A, N6782A)
:WINDow
[:TYPE] HANNing | RECTangular, (@chanlist)
Selects measurement window (N676xA, N678xA SMU, Option 054)
[SOURce:]
CURRent
[:LEVel]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the output current
:TRIGgered [:AMPLitude] <NRf+>, (@chanlist)
Sets the triggered output current
:LIMit
[:POSitive]
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the positive current limit (only on N678xA SMU, N6783A)
:COUPle <Bool>, (@chanlist)
Sets the current limit tracking state (only on N678xA SMU)
:NEGative
[:IMMediate][:AMPLitude] <NRf+>, (@chanlist)
Sets the negative current limit (only on N678xA SMU, N6783A-BAT)
:MODE FIXed | STEP | LIST, (@chanlist)
Sets the current trigger mode
:PROTection
:DELay
[:TIME] <NRf+>, (@chanlist)
Sets the over-current protection programming delay
:STARt SCHange | CCTRans, (@chanlist)
Sets the over-current protection programming mode
:STATe <Bool>, (@chanlist)
Enables/disables over-current protection on the selected output
:RANGe <NRf+>, (@chanlist)
Sets the output current range
:SLEW
[:IMMediate] <NRf+> | INFinity, (@chanlist)
Sets the output current slew rate (only N678xA SMU)
:MAXimum <Bool>, (@chanlist)
Enables/disables the maximum slew rate override (N678xA SMU)
DIGital
:INPut:DATA?
Reads the state of the digital port pins
:OUTPut:DATA <NRf>
Sets the digital port
:PIN<1-7>
:FUNCtion DIO | DINPut | TOUTput | TINPut | FAULt
| INHibit | ONCouple | OFFCouple
Sets the selected pin’s function
:POLarity POSitive | NEGative
Sets the selected pin’s polarity
:TOUTput
:BUS[:ENABle] <Bool>
Enables/disables BUS-generated triggers on digital pins
FUNCtion CURRent | VOLTage, (@chanlist)
Specifies current priority or voltage priority mode (N678xA SMU)
LIST
(List commands only on N676xA, N678xA SMU and Option 054)
:COUNt <NRf+> | INFinity, (@chanlist)
Sets the list repeat count
:CURRent
[:LEVel] <NRf> {,<NRf>}, (@chanlist)
Sets the current list
:POINts? (@chanlist)
Returns the number of current list points