Programming instructions

Command Reference
Phase Modulation subsystem ([:SOURce])
Chapter 4 273
:PM[1]|2:INTernal[1]:SWEep:RATE
Supported PSG-A Series
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:RATE <val><unit>
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:RATE?
This command sets the sweep rate for a phase-modulated, swept-sine waveform.
The variable <val> has a minimum resolution of 0.5 hertz.
*RST
+
4.00000000E
+
002
Range 0.5HZ
−
100kHZ
Key Entry
ΦM Sweep Rate
Remarks Refer to “:PM[1]|2:INTernal[1]|2:FUNCtion:SHAPe” on page 275 for
the waveform selection.
:PM[1]|2:INTernal[1]:SWEep:TRIGger
Supported PSG-A Series
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TRIGger BUS|IMMediate|EXTernal|KEY
[:SOURce]:PM[1]|2:INTernal[1]:SWEep:TRIGger?
This command sets the trigger source for the phase-modulated, swept-sine waveform.
BUS This choice enables GPIB triggering using the *TRG or GET command or
LAN triggering using the *TRG command.
IMMediate This choice enables immediate triggering of the sweep event.
EXTernal This choice enables the triggering of a sweep event by an externally
applied signal at the TRIGGER IN connector.
KEY This choice enables triggering through front panel interaction by
pressing the
Trigger hardkey.
*RST IMM
Remarks Refer to “:PM[1]|2:INTernal[1]|2:FUNCtion:SHAPe” on page 275 for
the waveform selection.
Choices BUS IMMediate EXTernal KEY
Key Entry
Bus Free Run Ext Trigger Key