Programming instructions

Command Reference
Trigger Subsystem
Chapter 4 215
Trigger Subsystem
:ABORt
Supported All
:ABORt
This command causes the list or step sweep in progress to abort.
*RST N/A
Range N/A
Key Entry N/A
Remarks If INIT:CONT[:ALL] is set to ON, the sweep will immediately
re-initiate.
The pending operation flag affecting *OPC, *OPC?, and *WAI will
undergo a transition once the sweep has been reset.
:INITiate:CONTinuous[:ALL]
Supported All
:INITiate:CONTinuous[:ALL] ON|OFF|1|0
:INITiate:CONTinuous[:ALL]?
This command selects either a continuous or single list or step sweep.
ON (1) This choice selects continuous sweep where, after the completion of the
previous sweep, the current sweep will restart automatically or wait
until the appropriate trigger source is received.
OFF (0) This choice selects a single sweep. Refer to
“:INITiate[:IMMediate][:ALL]” on page 216 for single sweep triggering
information.
*RST 0
Key Entry
Sweep Repeat Single Cont
Remarks Execution of this command will not affect a sweep in progress.
Choices ON OFF 1 0