Programming instructions

Command Reference
System Subsystem (:SYSTem)
Chapter 4 213
:SSAVer:DELay
Supported All
:SYSTem:SSAVer:DELay <val>
:SYSTem:SSAVer:DELay?
This command sets the amount of time before the display light or display light and text
is switched off. This will occur if there is no input via the front panel during the delay
period.
The variable <val> is a whole number measured in hours.
*RST N/A
Range 1–12
Key Entry
Screen Saver Delay:
Remarks The setting enabled by this command is not affected by signal
generator power-on, preset, or *RST.
Refer to “:SSAVer:MODE” on page 213 for selecting the screen saver
mode.
:SSAVer:MODE
Supported All
:SYSTem:SSAVer:MODE LIGHt|TEXT
:SYSTem:SSAVer:MODE?
This command toggles the screen saver mode between light only or light and text.
LIGHT This choice enables only the light to turn off during the screen
saver operation while leaving the text visible on the darkened
screen.
TEXT This choice enables both the display light and text to turn off
during the screen saver operation.
*RST N/A
Key Entry
Screen Saver Mode
Remarks The setting enabled by this command is not affected by signal
generator power-on, preset, or *RST.
Choices LIGHt TEXT