Programming instructions

Command Reference
Status Subsystem (:STATus)
Chapter 4 203
:QUEStionable:NTRansition
Supported All
:STATus:QUEStionable:NTRansition <value>
:STATus:QUEStionable:NTRansition?
This command determines what bits in the Data Questionable Condition Register will
set the corresponding bit in the Data Questionable Event Register when that bit has a
negative transition (1 to 0).
The variable <value> is the sum of the decimal values of the bits that you want to
enable.
*RST N/A
Range 0–32767
Key Entry N/A
Remarks Refer to “Data Questionable Status Group” on page 120 and “Data
Questionable Transition Filters (negative and positive)” on page 122
for more information.
:QUEStionable:POWer:CONDition
Supported All
:STATus:QUEStionable:POWer:CONDition?
This command returns the decimal sum of the bits in the Data Questionable Power
Condition Register. For example, if the RF output signal is unleveled (bit 1), a value of 2
is returned.
*RST N/A
Range 0–32767
Key Entry N/A
Remarks Refer to “Data Questionable Power Status Group” on page 124 and
“Data Questionable Power Condition Register” on page 125 for more
information.
The data in this register is continuously updated and reflects current
conditions.