Programming instructions

Command Reference
Status Subsystem (:STATus)
Chapter 4 191
:OPERation:NTRansition
Supported All
:STATus:OPERation:NTRansition <value>
:STATus:OPERation:NTRansition?
This command determines what bits in the Standard Operation Condition Register will
set the corresponding bit in the Standard Operation Event Register when that bit has a
negative transition (1 to 0).
The variable <value> is the sum of the decimal values of the bits that you want to
enable.
*RST N/A
Range 0–32767
Key Entry N/A
Remarks Refer to “Standard Operation Status Group” on page 117 for more
information.
:OPERation:PTRansition
Supported All
:STATus:OPERation:PTRansition <value>
:STATus:OPERation:PTRansition?
This command determines what bits in the Standard Operation Condition Register will
set the corresponding bit in the Standard Operation Event Register when that bit has a
positive transition (0 to 1).
The variable <value> is the sum of the decimal values of the bits that you want to
enable.
*RST N/A
Range 0–32767
Key Entry N/A
Remarks Refer to “Standard Operation Status Group” on page 117 for more
information.