User manual

Operating Procedures 4
N9360A Multi UE Tester GSM User Manual 4-21
This section describes correction for RF test results in
Automatic Test. Each traffic channel (TCH) path loss can be set
on the [Configuration: Test Sequence] screen. This is the RF test
correction function in addition to the loss function in the
[Configuration] screen.
In addition to entering the loss values on the [Configuration]
screen, you can also enter the attenuation values to be used to
correct the RF test results with these values at each traffic
channel in the Automatic Test mode.
Determine and enter the appropriate attenuation values at each
traffic channel with the following procedure, caused by the
antenna coupler, RF cable or shield case to connect the mobile
phone to the Tester.
Step 1
Press the GSM softkey on the [Top Menu] screen to activate GSM
system. Refer to Selection of System on page 13 for detail.
Step 2
Press the Config softkey on the [Initial] screen, and then the Te st
Sequence softkey to display the [Configuration: Test Sequence]
screen.