User manual

Operating Procedures 4
N9360A Multi UE Tester GSM User Manual 4-15
Selection of the Function Mode on the Initial Screen
The Tester executes its initialization and self-test routine after
completion of system setting. The [Initial] screen is displayed
subsequently.
Press one of the softkeys to select a function mode.
Figure 4-10 [Initial] Screen
NOTE
When the Autoboot function is set to GSM or WCDMA and not to None, the
Tester will automatically enter the GSM or W-CDMA system mode if no
softkey is pressed within the specified time (10 to 60 seconds). When the
Tester is shipped, the AutoBoot function is set to
None. For details, see
AutoBoot on page 8.