User manual

Operating Procedures 4
N9360A Multi UE Tester GSM User Manual 4-7
Test Parameters, Test Items and Allowable Ranges
Depending on the function modes, the Tester has a number of
input fields to be specified or defined to configure a test flow,
test sequence and test condition. The allowable ranges for those
input fields depending on the radio systems are explained in
this manual. For a quick overview, refer to Appendix A Input
Fields and Allowable Choices or Ranges on page 1.
Selecting an Input Field and Specifying a Value
All input fields to be specified are highlighted and the circular
cursor is shown next to one of them.
To start, first select an input field and then specify a value to
the input field by the following procedure:
4 Softkey Menu Field The softkey labels are displayed in this field. Each label defines the function of
the corresponding softkey immediately next to the right of the label.
5 Screen Field A variety of information is displayed in this field depending on the operation
status. For example, in Automatic Test, the following information is displayed
in this field.
a) Test Flow: Location Update, MS Call, BS Call, etc.
b) Test results: P (pass) or F (fail).
c) Measurement Items: Peak TX Power, Frequency Error, etc.
d) Measurement Results: Pass/Fail or values.
e) Input field: Highlighted fields.
6 Message Field Operation message for test flow steps are displayed in this field.
In this field, the word surrounded by bracket denotes the softkey.
Table 4-1 Description of the Display Annotation
No. Name Description