User manual

4-4 N9360A Multi UE Tester GSM User Manual
4 Operating Procedures
Connection
Connecting a Mobile Phone
Connect a mobile phone to the Tester using any of the following
methods:
1 Using the Antenna Coupler
Connect the Antenna Coupler (type CAU-17) connector to the
RF IN/OUT connector on the front panel of the Tester. Insert the
antenna of the mobile phone into the hole of the Antenna
Coupler.
2 Using a User-Supplied RF Cable
If you have a cable which connects between the mobile phone's
RF port and the RF IN/OUT connector of the Tester, use it
instead of the Antenna Coupler.
3 Using the Shield Case
Connect the ANTENNA COUPLER IN/OUT connector of the
shield case (part number 0960-2540) to the RF IN/OUT
connector on the front panel of the Tester. Place the mobile
phone on the antenna coupler board inside the shield case using
the horizontal and vertical holders.
Connecting a Printer / USB Memory Device
1 Printer
To print screen hardcopies, if required, connect a printer to the Tester
as follows using an appropriate interface cable between the USB
connector on the rear panel of the Tester and the USB interface
connector of the printer. Use the recommended printer shown below.
Also, refer to the manual of the printer for operating the printer.
Recommended printer (operation confirmed by Agilent):
EPSON PM-G800