User manual

Operating Procedures 4
N9360A Multi UE Tester GSM User Manual 4-3
Preparation for Each Test
The following procedures are required before starting each test.
System Requirement
The following equipments are required to set up a test system:
• The Agilent N9360A Multi UE Tester.
• An RF cable, RF antenna coupler (type CAU-17) or shield case (part
number 0960-2540) to connect RF signals from/to the mobile phone
under test.
• A printer and a printer cable if required.
Installing the Test SIM
Insert the Test Subscriber Identity Module (SIM) provided by
the Agilent Technologies in the mobile phone before performing
any test because the Tester will not be able to perform
measurements with a SIM that is provided by the cell phone
operator or other Test SIMs.
CAUTION
Make sure that the input signal level does not exceed the maximum
level allowed. Otherwise, an accident or Tester failure may occur.
Figure 4-2 Typic a l Test S etu p of th e Test e r